Launch S2-2 Sensorbox DC USB Oscilloscope 2 Channels work with Pro3s+ V5.0, X431 PAD V/ PAD VII

Product Description

Launch S2-2 Sensorbox DC USB Oscilloscope 2 Channel

• X431 deice: X431 Pro3 APEX, PRO DYNO, PROS V5.0, X431 PRO TT, V V5.0, PRO3S+ V5.0
• IMMO Series: IMMO Elite, IMMO Plus
• Creader Series: CRP919X BT, CRP919E BT

Development Backgrounds:

The sensor is the signal input device of the vehicle ECU. It converts vehicle operating parameters such as vehicle speed, coolant temperature, engine speed, air flow, and throttle opening into electrical signals and sends them to the vehicle ECU. Then, the vehicle ECU adjusts the engine running status to maintain the engine in optimal condition. 

• Check the ECU itself works or not
• It supports manual write the waveform data
• Simulate working condition of sensors without replacing parts
• Simulate some special working condition of sensors without replacing parts
• Be used as Multimeter to measures resistance, voltage AC/DC, capacitance, frequency and pulse signals, etc.
• One click to enters the intuitive menu of sensor, actuator, defined/drawn the waveform, timing waveform, multimeter, system settings.

Launch S2-2 Sensorbox Functions:

LAUNCH S2-2 sensor box mainly includes "Sensor", "Actuator", "Defined/Drawn", and "Timing Waveform". 

 

Sensor: Is used to simulate the input signals of the automobile electronic control system, and the automobile computer adjusts the running state of the engine according to these parameters.

 

Actuator: Is used to simulate the output control signal of automobile electronic control system, so as to judge the working conditions of automobile actuators such as idle motor, EGR solenoid valve, etc.

 

Multimeter: Through this function, users can test voltage, resistance, and capacitance.

 

Defined:
 

Waveform: There are 9 waveforms to choose; Forward sine wave, reverse sine wave, forward square wave, reverse square wave, medium voltage, straight line, high / low voltage straight line, triangle wave, and trapezoidal wave.

 

• Frequency: Set the frequency of the selected waveform.
• Amplitude: Set the amplitude of the selected waveform.
• Offset: Set the offset of the selected waveform.
• Phase: Set the phase of the selected waveform.
• Duty cycle: Set the duty cycle of the selected waveform.
• Signal sync: Can cause CH1 and CH2 to output signals at the same time.

Hand-drawn:
 

Total frame: 1-3 (optional). Indicate the total number of output points

 

Generally, one waveform is composed of 100 points. The values 1-3 indicate that you can select 100, 200, or 300 points to form a waveform.

 

• Edit frame: You can edit a single frame or edit all
• Waveform: You can select a preset waveform and place it in the hand-drawing area
• Frequency: Frequency of a single frame (for 3-frame output, the total frequency is the set frequency/3)
• Amplitude: Amplitude of the output waveform
• Offset: Offset of the output waveform

 

Timing Waveform:
 

The function is used to match the timing waveform (crankshaft + camshaft) of the engine.

Email: sales@X431Shop.de

Jetzt Kontakt aufnehmen!